Blue point Microscan III Manual de usuario descargar pdf (Pagina 13)

Introduction Data Cable

2.4.2 USB Power

The scan tool can be powered by a personal computer (PC) when connected to the PC with a

standard USB cable. The scan tool automatically powers up when it is connected to a USB port.

2.5 Data Cable

A Data Cable is included with your scan tool. The data cable plugs directly into the 16-pin data link

connector (DLC) on all OBD-II/EOBD vehicles.

2.6 Disconnecting the Scan Tool from the Vehicle

Always make sure the scan tool is no longer communicating with the vehicle electronic control

module (ECM) before disconnecting the data cable. Opening the data cable connection while the

scan tool is actively communicating with the ECM may cause irreversible damage to the ECM on

some models. Refer to Stopping Vehicle Communication on page 45 for information on how to

properly end a diagnostic session.

Similarly, if the scan tool is disconnected while in the process of saving a movie or image file, or

performing any other data writing operation, the file or data may be lost or otherwise corrupted.

A “saving” icon displays on the title bar while the scan tool is writing data to a file and a “save

success” message momentarily displays when the process is complete. Make sure a movie is

completely saved before disconnecting power to the scan tool.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 71 72

Sin comentarios

Blue point Microscan III Manual de usuario Pagina 13